Western Unimount Plow Wiring Harness Diagram (2024)

FAQs

What does the isolation module do on a western plow? ›

When you push a button on your hand held controller, that information is passed onto the Isolation module in order to help notify the plow of the movement as well as pass this information to the hydraulic system. With a faulty Isolation Module, your Western plow will not operate.

The Isolator module is an automatic device that isolates a part of the loop by opening when the line voltage drops below 14Volts. These modules should be spaced between groups of sensors or modules in a loop to isolate the faulty area from the rest of the loop.

The Isolator is placed at intervals on the loop and ensures that, in the case of a short circuit, only the section between the isolators will be affected. When the short circuit is removed, the isolators automatically restore power and data to the isolated section.

Release the button to stop the blade at desired height. FLOAT* Press the LOWER button and hold 3/4 second to activate this mode. The FLOAT light in the upper left corner of the control face will illuminate. The blade will lower to the ground surface and follow the contour of the surface as it dips or rises.

To plow straight, the farmer must use his hood ornament – a gun sight – to line up the tractor with a distant landmark, like a notch in the mountains. By aiming for that notch, he can keep the tractor's path straight within about a foot.

The aim of ploughing is to scoop up an 8” deep by 12” wide piece of earth and turn it over 180 degrees, burying any crop residue or weeds in the process. This results in loosened soil which can be made into a seed bed.

Isolator module Working Principle

When the bus fails, the isolator module in the fire alarm control system can isolate the faulty bus part from the whole system, making sure that other parts of the system can work normally. Meanwhile, the isolator module also can help find out the faulty bus part.

The rubber snow deflector increases visibility and safety by keeping blowing snow off the windshield making it easier to get the job done faster. To extend the life of the rubber snow deflector, the first and most important step is conducting a proper install.

Introduction. The LIM800 Line Isolator Module is designed to be used on the MX addressable controller loop circuits. It monitors the line condition and when detecting a short circuit will isolate the affected section whilst allowing the rest of the address- ing circuit to function normally.

Linear actuators work the same way as stated above in these remote-controlled robots, controlling the angle and tilt of the snowplow, as well as engaging it in the first place.